Saturday, August 23, 2014

The Baofeng UV5R 2M/70cm Ham Radio

The Baofeng UV5R and variants like the UV5RA have become popular with preppers because they are a very low cost way to get into ham radio. Back in June a friend who is a new ham and I both picked up UV5RAs, and for the money, we’re both impressed with them.

As handy talkies (HTs), the Baofengs allow you to have a small, light, and inexpensive two-way radio for communication on the 2 meter (144 MHz) and 70 centimeter (440 MHz) ham bands. They can be used in simplex mode or with repeaters, allowing you to communicate over longer distances.

The Baofengs will also receive FM broadcast band stations, NOAA Weather broadcasts, and can be programmed to operate on FRS, GMRS, and MURS frequencies.

Note that the Baofengs are not FCC type-accepted for FRS, GMRS, or MURS, so it is illegal to transmit on these freqs with them unless it’s an emergency.

There are a few accessories you should get with one of these little HTs in order to maximize their usefulness:

  • The stock antenna sucks. The Nagoya NA-701 offers improved reception and transmission without being too long.
  • For use in a vehicle you want an external antenna. The Tram 1185 is an inexpensive mag mount antenna that works well. You’ll also need this jumper to go between the HT’s antenna connection and the Tram’s SO-239 plug.
  • This Baofeng speaker-mic will improve audio for both transmission and reception. (I originally got a Pofung speaker-mic but it was DOA. I returned it to Amazon on their dime and got the Baofeng branded speaker-mic in its place.)
  • When I’m using the UV5RA in my truck I use this battery eliminator to power the radio. Note that this is not a charger, despite the Amazon product description. Rather, it replaces the battery with a regulator that powers the radio from your vehicle’s 12V outlet.
  • Finally, programming the Baofeng by hand is a tedious, frustrating job. Save yourself a lot of aggravation and use your computer and this USB cable. If you already have a programming cable for Icom radios it will be compatible. Check out Miklor.com for troubleshooting any issues related to driver installation. Don’t use Baofeng’s software, which sucks. Rather, use the open source, free software CHIRP, which supports both the UV5R and many other radios. CHIRP is available for Windows, Mac OS X, Linux, and FreeBSD.

Everything linked above, including a radio, can be bought from Amazon for under $100.

Although my friend and I both got the UV5RA, were I purchasing again I’d probably go with the plain UV5R. The insides of the two radios are the same but there are extra capacity batteries that fit the UV5R that don’t fit the UV5RA.

This thread on Arfcom is a gold mine of information on how to get up and running with a Baofeng UV5R radio:

http://www.ar15.com/forums/t_10_22/664274_Baofeng_UV_5R_information.html

Despite their popularity, the Baofeng’s are low end radios. HTs from any of the Big Three – Icom, Kenwood, or Yaesu – will be sturdier and have better performance. But, they are a lot more expensive. E.g., even the relatively simple Yaesu FT-60R will run you more than three times the cost of a Baofeng UV5R. The Chinese radio is good if you’re on a tight budget or if you need to use a radio in an environment where it’s susceptible to loss or damage, and it’s cheap enough to keep extras on hand. If you have at least your Technician license or are looking to get it, the Baofeng UV5R is not a bad choice for an entry level radio.

No comments: