This week I've been off and thus had time to hit the range a few times. I've taken a few revolvers and run several loads over my Garmin Xero C1 Pro chronograph.
The Garmin is so compact and easy to use I just leave it in my range bag.
Among the guns I've taken is a new S&W Model 432UC. This is an Airweight J-Frame in .32 H&R Magnum. My intention for this is to replace my 1990s-vintage Model 632 Airweight as a carry gun. The 632 is a collectible, but more importantly, was a gift from my late father. I wouldn't want it taken into evidence should I ever need to use it.
I ran a few loads over the Garmin from the 432UC.
Factory loads:
High Desert Cartridge Company .32 H&R Magnum 98 grain wadcutter:
811 FPS / 143 ft. lbs.
Black Hills .32 H&R Magnum 85 grain JHP:
948 FPS / 170 ft. lbs.
A couple handloads:
.32 H&R Magnum, Lee TL314 90 grain SWC
3.6 grains Accurate No.2
930 FPS / 173 ft. lbs. ME
.32 S&W Long, Lee TL314 90 grain SWC
2.2 grains Titegroup
682 FPS / 93 ft. lbs. ME
Of these, the HDCC 98 grain wadcutter is my choice in a carry load. It's very controllable in the Airweight and should give plenty of penetration, enough to poke a 5/16" diameter hole well into an attacker's vitals.
I also chronographed some .38 Special.
Colt Detective Special 2"
Hornady 148 grain HBWC over 2.7 grains of Red Dot
697 FPS / 160 ft. lbs ME
Colt Detective Special 2"
Hornady 148 grain HBWC over 2.9 grains of Accurate No.2
750 FPS / 185 ft. lbs. ME
S&W Model 66-2 2.5"
Hornady 148 grain HBWC over 2.9 grains of Accurate No.2
748 FPS / 184 ft. lbs.
NOTE: The Colt is chambered for .38 Special while the S&W 66-2 is chambered for .357 Magnum. The longer chamber with .38 cartridges leads to some velocity loss.
S&W Model 15-3 4":
Hornady 148 grain HBWC
3.0 grains HP-38
727 FPS / 174 ft. lbs. ME
S&W Model 1905, 4th Change .32-20 4"
Desperado Cowboy Bullets 96 grain RNFP over 3.5 grains Titegroup
792 FPS / 134 ft. lbs. ME
S&W Model 10-8 3"
Hornady 158 grain LSWC over 3.5 grains Titegroup
726 FPS / 185 ft. lbs. ME
This load does about 775 FPS from a 4" barrel.
I've found that 3.5 grains of Titegroup under a 158 grain bullet in .38 Special approximates factory loads and is both accurate and pleasant to shoot in K-Frame and larger guns. The same bullet with 3.5 grains of Bullseye is roughly equivalent but in 2025, Bullseye is nearly impossible to find. In contrast, Titegroup is readily available.
No comments:
Post a Comment