Winchester 94 "Old Red"

I ordered this 1935-vintage Winchester 94 Sporting Rifle from a Gunbroker seller last Saturday and picked it up yesterday, along with a couple boxes of Remington .30-30 170 grain JSP ammo. To pay for it, I put a couple of other guns that were gathering dust on consignment.

It's drilled and tapped to accept a tang sight, one of which I may add.

Overall it's in excellent shape for a 91 year old rifle. The bore is excellent with sharp rifling, no pits, and a good crown. It was very clean. After I hosed out the old congealed oil the action works smoothly. The wood is sound and except for nine decades of dings the original varnish is in very good condition.

It should be a fine shooter and I plan to take it into the woods after whitetail next Fall.

There are 6 notches cut into the bottom of the stock (disclosed in the GB listing). The left side of the butt bears the initials, "RED," so I've named the rifle "Old Red."

Along with the rifle I bought two boxes of Remington .30-30 170 grain Core Lokt JSPs. I have reloading dies, a pound of IMR-3031, a brick of large rifle primers, a box of Hornady Interlock 170 grain JSP bullets, and 250 pieces of Starline brass on the way. I also have fifty 178 grain .310" bullets hand cast from Lyman No.2 alloy on the way from MOD Outfitters that I'm looking forward to loading for the old Winchester.

Today I slugged the bore by driving a .32 caliber bullet through it which allowed me to measure groove diameter. 

The rule of thumb for choosing the diameter of cast bullets for a rifle is to use those that are .001" to .002" over groove diameter. I'll load a few dummies with the .310" bullet to check functioning with, and also to verify that they chamber OK. Assuming all's good there I'll load up small batches of 10 with a couple different powders.